Jhd-2x16-i2c Proteus

But hardware isn't always available. This is where shines. Simulating a JHD-2x16-I2C in Proteus allows you to debug your code, test wiring, and perfect your I2C protocol handling before soldering a single component.

For the I²C bus to function correctly, you must add two —one for the SCL line and one for the SDA line. A standard value of 4.7kΩ is a good starting point for a 5V circuit and a 100kHz bus speed. Without these, the bus signals will be floating, and your simulation will likely not work. jhd-2x16-i2c proteus

Use the DF Robot LCD Point H library ( LiquidCrystal_I2C.h ). But hardware isn't always available