Xnx Universal Transmitter Quick Start Guide [portable] ★ Fresh

Swipe to accept the zero point. The display will show a "Zero Passed" message. Step 2: Span Calibration

Gently pull the display module forward and unclip its retaining tether to expose the terminal blocks underneath. Power and 4-20mA Signal Wiring (3-Wire Current Source) Xnx Universal Transmitter Quick Start Guide

Apply the calibration gas via the calibration splash guard or cup. Monitor the display until the reading stabilizes. Select to accept the span value. Swipe to accept the zero point

Set the current date and time to ensure accurate internal data logging. Step 2: Zero Calibration (Fresh Air Baseline) Power and 4-20mA Signal Wiring (3-Wire Current Source)

The unit is in a fault state; check the local display for active F-codes.

Before handling the equipment, ensure strict compliance with local safety regulations and plant procedures.

Monitor the real-time values on the display. Once the readings level off and remain stable, swipe to save the span setting.