Brushless Esc V2.3 Manual Jun 2026

Connect to the negative (-) terminal of the battery.

Troubleshooting: If you hear continuous rapid beeping, the ESC did not see the signal. Check your receiver binding and signal wire connection. brushless esc v2.3 manual

End of Report – now go make something spin. Connect to the negative (-) terminal of the battery

The V2.3 firmware allows users to modify performance characteristics to suit different applications. Programming can be done via your transmitter sticks or via an external LED Programming Card. Table of Programmable Values 1 Beep (Default) 2. Battery Type NiMH / NiCd 3. Low Voltage Cutoff Medium (3.2V/cell) High (3.4V/cell) Low (3.0V/cell) 4. Cutoff Mode Soft Reduce Power Hard Cutoff 5. Motor Timing 3.75∘3.75 raised to the composed with power 15∘15 raised to the composed with power 26.25∘26.25 raised to the composed with power 6. Startup Mode Menu Descriptions End of Report – now go make something spin

This is a much simpler and more intuitive method. You connect the program card between the ESC and receiver or directly to the ESC's programming port. The program card has an LCD screen and buttons, allowing you to clearly see and change all parameters easily. This method eliminates the need to listen for beep codes.

Before your first drive, you must configure the ESC to match your transmitter and preferences.