Leave the exact code and your application (freezer vs. cooler) in a comment below, and refer to your physical Eliwell SB655 C manual for verification.
: Use the UP and DOWN arrows to navigate folders and parameters. eliwell sb655 c manual
Check sensor wiring; replace probe if resistance is incorrect. Evaporator Probe (Pb2) Error Faulty sensor or disconnected cable Leave the exact code and your application (freezer vs
The SB655C offers a rich set of I/O to interface with a wide range of sensors and system components. Check sensor wiring; replace probe if resistance is
: Ensure you are reading the temperature correctly. On the display, the decimal point for the tenth of a degree is always in the lower section of the screen. An LED in the upper part can be mistaken for a decimal separator. Also, confirm that no external switches or the Economy function (which uses OSP ) are inadvertently shifting the target temperature.
: Press the SET key once to see the current setpoint; press again to see the value.
Copyright © 2014-2026 9jaflaver. All Rights Reserved.
About us | DMCA | Privacy Policy | Contact us
| Advertise| Request For Music | Terms Of Service
9jaflaver is not responsible for the content of external sites.
Eliwell Sb655 C Manual =link= <TESTED>
Leave the exact code and your application (freezer vs. cooler) in a comment below, and refer to your physical Eliwell SB655 C manual for verification.
: Use the UP and DOWN arrows to navigate folders and parameters.
Check sensor wiring; replace probe if resistance is incorrect. Evaporator Probe (Pb2) Error Faulty sensor or disconnected cable
The SB655C offers a rich set of I/O to interface with a wide range of sensors and system components.
: Ensure you are reading the temperature correctly. On the display, the decimal point for the tenth of a degree is always in the lower section of the screen. An LED in the upper part can be mistaken for a decimal separator. Also, confirm that no external switches or the Economy function (which uses OSP ) are inadvertently shifting the target temperature.
: Press the SET key once to see the current setpoint; press again to see the value.